Cold plastic stochastic structures - the best way to apply
Stochastic agglomerate markings with 2-component cold plastic, mixing ratio 98:2, applied with:
- bellow pump system (path-dependent)
- universal extruder system (path-depenent)
- pressurised container system (non path-dependent)
- Screed box system (non path-dependent)
Features
Available application techniques
2 component cold-plastics
Marking system for agglomerate markings, which efficiently applies structure markings on the road in order to increase night visibility during rain and wet conditions.
These structure markings can be renewed (re-marked) or can be applied on already existing road markings in case a plain effect is requested during daylight and reduced inspection distance.
Application of whole container filling without intermediate flushing of the corresponding systems (bellow pump, extruder and pressurised container) thus longer stops can be avoided.
Exact compliance of mixing ratio, therefore mixing as a matter of trial and error is eliminated.
Marking speeds up to 10 km/h*) can be achieved (bellow pump, extruder and pressurised container). Using the screed box system up to 4 km/h*).
Suitable for the application of highly abrasive mediums and solid matters with a size of up to Ø 2,5 mm (bellow pump and pressurised container) as well as up to Ø 0,6 mm (extruder and screed box).
Due to the optimum drainage the peaks of the stochastic marking remains reachable for headlights and will reflect even during heavy rainfall.
Acoustic warning signal in case of lack of hardener.
Using the bellow pump system double lines and line combinations in one single marking operation are possible. Using the pressurised container system double lines are also possible, however line combinations only restricted.
Fulfillment of regulations is ensured with regard to automatic compliance of adjusted line thickness/material quantity.
Possibility to use AMAKOS® method of operation.
*) dependent on material and equipment, continuous line, line width 12 cm
Function Principle
Available application techniques
2 component cold-plastics
- Dynamic mixing system for mixing of the two components
- Dosage of 2 % hardener component by means of a plunger pump (bellows pump system) or gear pump (universal extruder system) as well as 98 % base component by the bellows pump or the extruder
- Spiked roller for generating stochastic agglomerates