H10-2
A machine with unique maneuverability as well as ideal cornering characteristics
Figure: Example machine out of H10-2 product line
Available Application techniques
Description
Hydraulic drive with wheel motor for infinitely variable speed regulation. Mechanical parking brake.
Two rear wheels, one driven front wheel which can be turned to the right and left by almost 80° via steering. This allows an extremely small turning circle of 3.8 m (around stationary right or left rear wheel).
Good visibility conditions during marking operation.
Line widths:
10 up to 30cm (dependent on equipment)
Specifications
2-cylinder 690 cm³,
Honda gasoline engine,
air-cooled
14,5 kW at 3 200 rpm
Air output:
up to 670 l/min at 6,0 bar (2-cyl. compressor)
Pressurised glass bead containers:
35 l (max. 1 bar)
Turning cycle: Ø 3,8 m
(dependent on equipment)
Dimensions (L x W x H mm):
2650 x 1050 x 1600 (dependent on equipment)
Weight, equipped:
approx. 650 - 950 kg
approx. 1 433 - 2 095 lbs
Techniques / Container volumes: (dependent on equipment)
| Cold paints | up to 140 ltr |
| Sprayable 2-component spray-plastics | up to 90ltr |
| Thermoplastics | up to 100 ltr |
| Sprayable Thermoplastics | up to 50 ltr |
Photos
Videos
Equipments
Accessories
Preheaters
Marking Patterns
Available Application techniques
Remarks
All information is given without the use of glass bead guns, since in this case the required air flow rate has to be calculated.
The line widths and gaps for double lines depend on the equipment.
Combined double lines, especially for hand-guided machines, are often dependent on the equipment and require, among other things, the addition of higher-grade line-gap electronics.
Special solutions on request.
