H16-3
A narrow, manoeuverable machine with small capacities
Figure: example machine out of H16-3 product line
Available Application techniques
Description
Hydraulic drive with wheel motor with infinitely variable speed adjustment
Hydraulic multi-disk parking brake
Large axle base and front wheel steering system with zero backlash for best roadability and excellent handling, especially wherever the marking results depend on high manoeuvrability
Application units favourably mounted in the back of the machine
Low position of driver’s seat as well as platform; comfortable get on / off
Engine compartment easily accessible for service work
Line widths:
10 up to 50 cm (dependent on equipment)
Specifications
Version I**):
4-cylinder 1 500 cm³,
Kubota Diesel motor,
water-cooled, Non label
(comparable to EU Stage IIIA resp.
(US) EPA Tier 2)
26,2 kW at 3 000 rpm
Version II**):
4-cylinder 1 500 cm³,
Kubota Turbo Diesel motor,
water-cooled, low-emission
EU Stage IIIA resp.
(US) EPA Tier 4 Interim
26,2 kW at 3 000 rpm
** further exhaus stages upon request
Air output:
up to 1000 l/min at 6 bar (2-cylinder compressor)
Glass bead container:
70 l
Dimensions (L x W x H mm):
3950 x 1325 x 1650 (dependent on equipment)
Techniques / Container volumes: (dependent on equipment)
| Cold paints | up to 225 l |
| 2-component cold-plastics | up to 225 l |
| Sprayable 2-component spray-plastics | up to 225 l |
| Thermoplastics | up to 200 l |
| Sprayable Thermoplastics | up to 200 l |
Photos
Videos
Equipments
Accessories
Preheaters
Specialties
Marking Patterns
Available Application techniques
Remarks
All information is given without the use of glass bead guns, since in this case the required air flow rate has to be calculated.
The line widths and gaps for double lines depend on the equipment.
Combined double lines, especially for hand-guided machines, are often dependent on the equipment and require, among other things, the addition of higher-grade line-gap electronics.
Special solutions on request.
